Steps
1. Align the numbering on the processor fan and heat-sink assembly with the numbering on the system board.
2. In the sequential order (1->2->3->4), tighten the captive screws that secure the processor fan and heat-sink assembly to the system
board.
3. Connect the processor-fan cable from the system board.
Next steps
1. Install the left-side cover.
2. Follow the procedure in After working inside your computer.
Processor
Removing the processor
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the left-side cover.
3. Remove the processor fan and heat-sink assembly.
NOTE:
The processor might still be hot after the computer is shut down. Allow the processor to cool down before
removing it.
About this task
The following images indicate the location of the processor and provide a visual representation of the removal procedure.
46
Removing and installing components
To Next Page
Loading...
