Installing the 3.5-inch hard drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
NOTE: You may install two 3.5-inch hard drives into your computer, one into each hard-drive cage on the chassis.
The following image(s) indicate the location of the 3.5-inch hard drive and provides a visual representation of the installation
procedure.
Steps
1. Place the 3.5-inch hard drive into the hard-drive carrier and align the tabs on the carrier with the slots on the hard drive.
2. Snap the hard-drive carrier onto the 3.5-inch hard drive.
3. Slide the hard-drive assembly into the hard-drive cage until it snaps into place.
4. Connect the hard-drive data cable and power cable to the 3.5-inch hard drive.
5. Place the computer in an upright position.
24
Removing and installing components
To Next Page
Loading...
