Steps
1. Align the notch on the 2290 solid-state drive with the tab on the M.2 card slot on the system board.
2. Slide the 2280 solid-state drive into the M.2 card slot on the system board.
3. Replace the screw (M2x3) that secures the 2280 solid-state drive to the system board.
4. Place the computer in an upright position.
Next steps
1. Install the left-side cover.
2. Follow the procedure in After working inside your computer.
Removing and installing the M.2 screw mount
About this task
The following image provides a visual representation of the procedure to remove and install the M.2 screw mount on the system
board. Which will allow the conversion of the slot for M.2 2230 and 2280 solid-state drives.
Removing and installing components
33
To Next Page
Loading...
