Adjusting of the minimum of the top burners
Considering that in the minimum position the flame must have a length of about 4 mm and
must remain lit even with a quick turn from the maximum position to that of minimum.
The flame adjustment is done in the following way:
– Turn on the burner
– Tum the tap to the MINIMUM position
– Take off the knob
– With a small flat screwdriver turn the screw inside the tap rod to the correct regulation (fig.
29).
Normally for LPG, tighten up the regulation screw.
Fig. 29
Conversion to LPG
Injectors replacement of top burners
Every cooker is provided with a set of injectors for the various types of gas.
Injectors not supplied can be obtained from the After-Sales Service.
Select the injectors to be replaced according to the table at page 29.
The nozzle diameters, expressed in hundredths of a millimetre, are marked on the body
of each injector.
To replace the injectors proceed as follows:
– Remove the grids and extract the burner bodies.
– Using a wrench, substitute the nozzle injectors “J” (Fig. 28) with those most suitable for
the kind of gas for which it is to be used (see “Table for the choice of the injectors”).
The burners are conceived in such a way so as not to require the regulation of the
primary air.
Fig. 28
J
29
To Next Page
Loading...
