DeLonghi ESAM2502 - Cleaning the Infuser; Cleaning the Pre-Ground Coffee Funnel; Descaling

32
22 23
13.7 Cleaning the pre-ground coee funnel
Check regularly (about once a month ) that the pre-ground
coee funnel (A6) is not blocked. If necessary, remove coee
deposits with a brush.
13.8 Cleaning the infuser
The infuser (A11) must be cleaned at least once a month.
Important!
The infuser must not be extracted when the machine is on.
1. Make sure the machine is correctly turned o (see “7.
TURNING THE APPLIANCE OFF”).
2. Open the service door
3. Extract the drip tray and the grounds container (g. 18).
4. Press the two red release buttons inwards and at the same
time pull the infuser outwards (g. 24).
24
Important!
RINSE WITH WATER ONLY
NO WASHING UP LIQUID  NO DISH WASHER
Do not use washing up liquid to clean the infuser as it could
cause damage.
5. Soak the infuser in water for about 5 minutes, then rinse
under the tap.
6. After cleaning, replace the infuser by sliding it onto the in-
ternal support and pin at the bottom, then push the PUSH
symbol fully in until it clicks into place.
Please note:
If the infuser is dicult to insert,
before insertion, adapt it to the
right size by pressing the two le-
vers shown in the gure.
7. Once inserted, make sure the two red buttons have
snapped out.
8. Close the infuser door.
9. Replace the water tank.
14. DESCALING
Descale the appliance when the light on the panel ash-
es.
Important!
• Descaler contains acids which may irritate the skin and
eyes. It is vital to respect the manufacturer’s safety warn-
ings given on the descaler pack and the warnings relating
to the procedure to follow in the event of contact with the
skin and eyes.
• You should use De’Longhi descaler only. Using unsuitable
descaler and/or performing descaling incorrectly may re-
sult in faults not covered by the manufacturer’s guarantee.
1. Turn the machine on.
2. Empty the water tank (A12).
3. Pour the descaler diluted with water (respecting the pro-
portions indicated on the descaler pack) into the water
tank.
Place an empty container with a minimum capacity of 1.5
litres under the hot water spout.
4. Wait for the and lights to come on steadily.
Important! Danger of burns
Hot water containing acid ows from the cappuccino maker.
Avoid contact with splashes of water.
5. Press the button and hold it down for at least 5
seconds to conrm that you have added the solution and