DeLonghi Magnifica Start - Rinsing; Tips for a Hotter Coffee; Adjusting the Coffee Mill; Customizing the Quantity in the Cup

10
2. Select the desired coee drink.
Please note:
• When the next coee is made, the machine will show the
last intensity setting selected.
• In the event of power failure, the machine will revert to
the default setting: medium.
8.6 Rinsing
Using this function, hot water can be delivered from the coee
spouts to clean and heat the internal circuit of the machine.
1. Place a container of at least 100ml capacity under the cof-
fee spouts (A16) (g. 5).
2. Press the button (B4) and hold for at least 5 seconds:
the cycle will start and stop automatically (to terminate
the cycle sooner, press this same button a second time).
Please note:
• If the machine is not used for more than 3-4 days it is
highly advisable, when switching on again, to run 2/3
rinse cycles before preparing any drinks;
• It is normal for the grounds container (A10) to contain
water following a rinse cycle.
8.7 Tips for a hotter coee
To make a hotter coee, proceed as follows:
• run a rinse cycle (see section “8.6 Rinsing”);
• warm the cups using the Hot water function;
• set a higher coee temperature via the menu (see section
“12. Settings menu”).
8.8 Adjusting the coee mill
The coee mill does not require any adjustment, at least initial-
ly, as it has been factory set to ensure that coee is prepared
correctly.
Please note:
The adjustment dial must be turned only when the coee mill
is in operation during the initial step of coee preparation.
To make an adjustment while the coee mill is in operation,
turn the dial (A2) as follows:
If the coee is delivered too
slowly, or not at all.
The eect of this adjustment will
not be noticeable until at least 2
further coees have been made.
Turn one click toward num-
ber “7”
For a fuller bodied and
creamier coee
The eect of this adjustment will
not be noticeable until at least 2
further coees have been made.
Turn one click toward num-
ber “1”
Please note:
• To interrupt delivery, press any drink selection button.
• At the end of delivery, to increase the quantity of coee in
the cup, simply press and hold the drink selection button
(within 3 seconds); the Led will blink rapidly.
8.9 Customizing the quantity in the cup
1. Press the button relative to the drink being programmed
and hold for a few seconds: when the Led corresponding
to the selection blinks rapidly, the machine is in program-
ming mode. Delivery begins;
2. Once the cup is lled to the desired level, press the button
again: delivery ceases and the quantity is stored.
Please note:
To cancel the current setting, press a button corresponding to an -
other drink.
9. MAKING MILKBASED DRINKS
Please note:
• Before using the carafe, check that all the components are
cleaned and assembled as described in section “14. Thor-
ough cleaning of milk carafe”
• To ensure that milk is not under-frothed or topped with
large bubbles, always clean the milk container lid (E1)
and the carafe connector (E6) as described in sections “9.6
Cleaning the milk carafe after each use”, and “14. Thor-
ough cleaning of milk carafe”.
9.1 What milk to use?
The quality of the froth will vary depending on:
• the temperature of the milk or vegetable drink used (for
best results, always use milk or vegetable drink straight
from the fridge, 5 °C);
• type of milk or vegetable drink;
• the brand used;
• ingredients and nutritional values.
Cow's milk
→