9
Drink
(*)
Default
quantity
(ml)
Programmable
quantity (ml)
40
from ≃ 20 to ≃
180
180
from ≃ 100 to ≃
240
120
from ≃ 80 to ≃
180
(*)
Numbers and types of drinks dier according to model.
5. Preparation begins and the Led corresponding to the se-
lection blinks on the control panel (B).
8.2 Making 2 cups of coee
1. Place the cups under the coee spouts (A16);
2. Lower the spouts as near as possible to the cups: this
makes a creamier coee;
3. Press the button (B2): the corresponding Led
lights up;
4. Press the button (B8);
5. Preparation begins and the Led corresponding to the Es-
presso button blinks on the control panel (B).
8.3 Making coee using pre-ground coee
Important!
• Never add pre-ground coee when the machine is o, or
it could spread through and soil the inside of the machine.
This could cause damage to the machine.
• Never use more than 1 level
measure (D2), as this could soil
the inside of the machine or
block the funnel (A4).
Please note:
When using pre-ground coee, only one cup can be made at
a time.
1. Press the button (B5) repeatedly until the Led
lights up (B7).
2. Make sure the funnel is not blocked, then add one level
measure of pre-ground coee (g. 16).
16
3. Place a cup under the coee spouts (A16) (g. 15);
4. Select the required drink (B8);
5. Preparation begins and the Led corresponding to the se-
lection blinks on the control panel (B).
Important!
• It is not possible to make a Doppio+ coee using
pre-ground coee.
8.4 General indications for making coee-
based drinks
• Indicator lights may appear on the control panel (B) dur-
ing use. Their meaning is given in section “17. Explanation
of lights”.
• To make a hotter coee, see section “8.7 Tips for a hotter
coee”.
• If the coee is delivered a drop at a time, too weak and
not creamy enough or too cold, read the tips in section
“18. Troubleshooting”.
• To customize drinks according to personal taste, see sec-
tions “8.5 Varying the intensity of the coee” and “8.9
Customizing the quantity in the cup”.
Please note:
In energy saving mode, a few seconds may elapse before the
rst coee is delivered as the machine must heat up again.
8.5 Varying the intensity of the coee
1. Press the button (B5) repeatedly until the Leds
relative to the desired intensity light up (B6):
Mild
Medium
Strong