DeLonghi Magnifica Start - Troubleshooting Common Machine Issues; Resolving Power, Temperature, and Grind Issues

23
Indicator/Led Meaning
Descaling has been inter-
rupted. Complete the cycle,
restarting from the step
indicated by the intensity
selection Leds.
→
Indicator/Led Meaning
1 2 3 4 5
Descaling in progress
1 2 3 4 5
Installation/Replacement
of water lter softener
progress
18. TROUBLESHOOTING
Possible malfunctions of the machine are listed below.
If the problem cannot be resolved as described, contact Customer Service.
Problem Cause Solution
The appliance does not switch on. The cord is not plugged into the mains
socket.
Plug into the mains socket.
The coee is not hot. The cups were not preheated. Warm the cups by rinsing them with hot
water (Please note: the hot water func-
tion can be used).
The internal circuits of the appliance have
cooled down because 2-3 minutes have
elapsed since the last coee was made.
Before making coee, warm the internal cir-
cuits by pressing and holding the but-
ton (B4) for a few seconds to run a rinse cycle.
Coee temperature setting too low. Select a hotter coee temperature in the
settings menu (see “12. Settings menu”).
The machine needs descaling Run the descale procedure. Next, check
the water hardness (“5. Measuring water
hardness”) and make sure the machine
setting matches the local water supply
hardness (“12. Settings menu”).
The coee is weak or not creamy enough. Coee ground too coarsely. Adjust the grinding level (“8.8 Adjusting
the coee mill”). The eect will not be
noticeable until at least 2 coees have
been made.
Coee not suitable. Use coee for espresso machines.
Coee not fresh. The coee pack has been opened for too
long and has lost its taste.
→