17
Component Frequency Procedure
Grounds container
When the indicator lights up, the
grounds container must be emptied: the
machine cannot now make coee.
• Remove the drip tray, empty and clean.
• Empty the grounds container and clean thoroughly
to remove all residues that may have collected on
the bottom.
• Check the condensate tray (colour red) and if full,
empty if out.
The appliance cannot be used to make coee again until the grounds container has been cleaned. The
machine will display the message indicating the need to empty the grounds container 72 hours after
the rst coee has been prepared, even if the container is not full (for the 72 hours to be calculated
correctly, the machine must never be disconnected from the mains power supply).
Drip tray components The drip tray is tted with a level indi-
cator (colour red) showing the level of
water it contains.
Before the indicator projects from the cup
tray, the drip tray must be emptied and
cleaned
• Remove the drip tray and the grounds container;
• Remove the cup tray and drip tray grille, then
empty the drip tray and the grounds container and
wash all components;
• Check the red condensate tray and, if full, empty if
out;
• Reposition the drip tray complete with grille, and
the grounds container.
When removing the drip tray, the grounds container
must also be emptied, even if it is not completely full.
Inside of the machine Check periodically (about once a month)
that the inside of the machine (accessible
by removing the drip tray) is not dirty.
Switch the machine o and isolate it from the power
supply. Never immerse the machine in water.
• Remove coee deposits with a brush and sponge;
• Remove all residues with a vacuum cleaner
Coee spouts Clean the coee spouts periodically (once
a month)
• Clean the coee spouts periodically with a sponge
or cloth;
• Check that the holes in the coee spout are not
blocked. If necessary, remove coee deposits with
a toothpick.