EasyManua.ls Logo

Delta Electronics ASD-A3023MA User Manual

Delta Electronics ASD-A3023MA
383 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Call 1(800)985-6929 for Sales
deltaacdrives.com
sales@deltaacdrives.com
Call 1(800)985-6929 for Sales
deltaacdrives.com
sales@deltaacdrives.com

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the Delta Electronics ASD-A3023MA and is the answer not in the manual?

Delta Electronics ASD-A3023MA Specifications

General IconGeneral
BrandDelta Electronics
ModelASD-A3023MA
CategoryDC Drives
LanguageEnglish

Summary

1.3 Servo Drive and Servo Motor Combinations

2.1 Installation Notes

2.3 Installation Conditions

2.4 Installation Procedure and Minimum Clearances

3.1.2 Servo Drive Connectors and Terminals

3.1.3 Wiring Methods

3.2 Basic Wiring

3.3 Input / Output Interface Connector -CN1

3.3.2 Signals Explanation of Connector CN1

Detailed explanation of signals for general, digital output, and digital input groups.

3.4 Encoder Connector CN2

3.5 Serial Communication Connector CN3

3.6 Standard Connection Example

Chapter 4 Display and Operation

4.3 Status Display

Explains various status messages like Save Setting, Fault, and Polarity.

4.4 General Function Operation

Covers general operations like fault code display, JOG, and position learning.

Chapter 5 Trial Run and Tuning Procedure

5.1 Inspection without Load

Steps for inspecting the drive and motor before trial run without load.

5.2 Applying Power to the Drive

Step-by-step guide for connecting power and turning on the servo drive.

5.3 JOG Trial Run without Load

Instructions for performing a JOG trial run without connecting a mechanical system.

5.6 Tuning Procedure

Guidance on tuning the servo drive, including flowcharts and methods.

Chapter 6 Control Modes of Operation

6.1 Control Modes of Operation

Lists and describes the six single and five dual control modes available.

6.2 Position Control Mode

Details position control modes, including command sources and structure.

6.3 Speed Control Mode

Details speed control modes, including command sources and structure.

Chapter 7 Servo Parameters

Chapter 8 MODBUS Communications

8.1 Communication Hardware Interface

Describes communication modes (RS-232, RS-485, RS-422) and their configurations.

8.2 Communication Parameter Settings

Explains communication addresses and transmission speed settings.

Chapter 9 Maintenance and Inspection

9.1 Basic Inspection

General inspection procedures before operation and during operation.

Chapter 10 Troubleshooting

10.1 Fault Messages Table

Lists fault codes, names, and descriptions for servo drive errors.

10.2 Potential Cause and Corrective Actions

Details potential causes and corrective actions for common servo drive faults.

10.3 Clearing Faults

Methods for clearing various fault messages by resetting or specific actions.

Chapter 11 Specifications

Chapter 12 Application Examples

Related product manuals