WIRE
COLOR
NOTES
Red
It is recommended to install an appropriate
size fuse from the battery terminal to the
vehicle system. This may also prevent
damage to the charger.
Black
Important: Connect the ring terminal with
overmould directly to the battery negative
post; if not, the sensor will not have accurate
battery temperature information and charge
performance may be affected.
If this cable end is damaged, or if the negative
wire needs to be separated from the thermistor,
a Thermistor Repair Kit
(Part Number 900-0002) is available.
White
Green
Internally connected to Battery Positive when
charger is not connected to AC power.
Important: Install a 1A fuse inline to avoid
damage to the internal relay. Do not allow
this wire to contact Battery Negative.
NOTE: On 24V-72V units, the standard
interlock will be set to B+ even when the
charger is connected to AC Power when the
charger is in Fault State 1, 2, or 6.
Table 3-2
Electrical Installation
32
To Next Page
Loading...
Need help?
General
