15
ADJUSTING HOLDDOWN
The holddown (A) Fig. 34, should be adjusted so it
contacts the top surface of the work being cut by
loosening lock handle (B) and moving holddown rod (C)
up or down. Then tighten lock handle (B).
ADJUSTING DUST BLOWER
The dust blower (A) Fig. 35, may be moved to direct air
to the most effective point on the cutting line by loosening
screw (B), adjust nozzle (A), and tighten screw (B).
Fig. 34
A
B
C
Fig. 35
B
A
To Next Page
Loading...
