Need help?Do you have a question about the Delta 28-641 and is the answer not in the manual?
General| Type | Band Saw |
|---|---|
| Blade Length | 93.5 inches |
| Blade Width | 1/8 to 3/4 inches |
| Cutting Capacity Height | 6 in. |
| Cutting Capacity Width | 13.5 inches |
| Voltage | 120V |
Essential precautions for personal safety, machine handling, and workspace organization.
Specific instructions for safe blade use, workpiece control, and machine operation.
Rules for work area, unattended operation, health, and dust control.
Guidance on handling damaged parts, seeking additional information, and safety references.
Instructions and warnings for safely removing the bandsaw from its packaging.
Procedure for removing rust preventive coating using specified solvents.
Guidelines for choosing a stable and level foundation for the bandsaw.
Steps for attaching the table assembly to the bandsaw machine.
Instructions for connecting the dust chute to the bandsaw.
Procedure for mounting and positioning the fence onto the table.
Recommendations for matching machine rating to power system and wire gauge.
Steps for connecting a 230V single-phase bandsaw to a grounded receptacle.
Procedure for connecting a 230V three-phase bandsaw to the power source.
Location and function of the start and stop buttons on the bandsaw column.
How to use the blade brake to stop the bandsaw blade after operation.
Method for setting correct blade tension using the handwheel and scale.
Procedure for centering the blade on the upper wheel for accurate cuts.
Steps for positioning the upper blade guide close to the material.
Fine-tuning upper blade guides and support bearing for blade alignment.
Procedure for adjusting lower blade guides and support bearing for proper blade support.
Instructions for tilting the bandsaw table for angled cuts.
How to check and adjust the table's positive stop for 90-degree positioning.
Steps for adjusting the fence to ensure parallel rip cuts.
Step-by-step guide for safely removing and installing bandsaw blades.
Procedure for adjusting the drive belt tension on the bandsaw.
Information on the dust chute and its connection to a dust collection system.
How to use and adjust the wheel brush for cleaning blade tires.
Locations and method for lubricating blade guides and support bearings.
Information on obtaining parts, service, and warranty assistance from Delta.
Terms and conditions of the Delta Two Year Limited Warranty for machinery.
To Next Page
