Need help?Do you have a question about the Delta 28-255 and is the answer not in the manual?
General| Type | Table Saw |
|---|---|
| Blade Diameter | 10 inches |
| Blade Length | 10 inches |
| Blade Width | 0.125 inches |
| Arbor Size | 5/8 inches |
| Bevel Capacity | 0-45 degrees |
| Voltage | 120V |
| Dust Port Size | 4 in. |
Comprehensive list of precautions for safe operation, maintenance, and workshop practices.
Covers blade guides, tension, tracking, feeding speed, and stopping procedures.
Instructions for unpacking, removing protective coating, and waxing the band saw.
Attaching the foot lever and caster assemblies to the mobile base.
Instructions for leveling the base and ensuring the foot lever is raised.
Procedures for raising and lowering the mobile base for movement.
Steps for preparing the stand and removing its side panels.
Mounting the motor onto support bars and positioning the stand.
Routing the power cord and placing the stand on the mobile base.
Attaching the motor pulley and securing the band saw unit to the stand.
Aligning pulleys and adjusting V-belt tension for proper operation.
Attaching the belt and pulley guard to the stand.
Ensuring power disconnection, cable tie importance, and switch box installation.
Attaching the rear and front guide rails to the band saw table.
Inserting the fence and adjusting its height for proper alignment.
Aligning the fence parallel to the miter gage slot.
Ensuring fence perpendicularity and aligning the pointer to the guide rail mark.
Requirements for electrical circuits, wiring, and fuses for safe power connection.
Details on voltage, frequency, and switch position for motor operation.
Explains grounding for shock protection and proper connection methods.
Guidance on choosing the correct gauge and condition for extension cords.
Instructions for operating the on/off switch and securing it with a padlock.
Procedure for correctly installing the table insert.
Steps for tilting the table right and left using locking knobs.
Adjusting the table stop to ensure a perfect 90-degree angle to the blade.
Instructions for setting blade tension and releasing it when not in use.
Adjusting blade guides for tracking and safety warnings.
Adjusting the upper guide assembly and ensuring blade guides are flat.
Setting blade guides and the support bearing relative to the blade.
Adjusting the lower blade guides and support bearing.
Steps for safely removing and installing a new band saw blade.
Information on choosing, using, caring for blades, and their lengths.
Verifying adjustments, safe handling, and keeping the blade sharp.
Methods for safely cutting curves and performing resawing operations.
Information on contacting Delta for parts, service, and warranty assistance.
Overview of Delta's two-year limited warranty terms and conditions.
To Next Page
