10
6. Remove screw and cable clamp (E) Fig. 21, from
lower arm of band saw.
7. Insert switch cord (F) Fig. 21, into clamp (E) which
was removed in STEP 6, and fasten switch cord (F) to
band saw as shown. IMPORTANT:CHECK AND MAKE
CERTAIN THE ON/OFF SWITCH-TO-MOTOR CORD
(F) F I G . 18, IS NOT CONTACTING M O TO R PULLEY O R
BELT.ADJUST C O RD (F) FIG.18,IF NECESSARY,
THEN TIGHTEN CABLE TIE (H).
Fig. 21
ASSEMBLING RIP FENCE
1. MAKE CERTAIN THE MACHINE IS DISCON-
NECTED FROM THEPOWERSOURCE.
2. Assemble rear guide rail (A) Fig. 22, to band saw
table using 1/4-28 x 1 hex socket head screws (B), at
locations (C). Do not completely tighten hardware at this
time.
3. Assemble front guide rail (D) Fig. 23, to band saw
table using 1/4-28 x 1-1/4 hex socket head screws (E),
and spacers (F), at locations (G). Position sp acers
between t able and guide rail.
Fig. 22
A
B
B
C
Fig. 23
F
F
E
D
G
E
E
F
To Next Page
Loading...
