15
Fig. 37
Fig. 38
Fig. 39
ADJUSTING TABLE STO P
The band saw is equipped with an adjust able t able stop
(B) Fig. 38, that allows the t able to be set perfectly at
90 degrees with the blade.
Tilt the t able to the lef t until the t able stop (B) Fig. 38,
cont act s the bottom of the t able. Place a square on the
table and against the blade as shown in Fig. 39, and
check to see if the blade is 90 degrees to the t able sur -
face. If an adjustment is necessary, proceed as follows:
1.Tilt the t able slightly to the right and tighten t able lock
knobs.
2. T urn adjustment nut (C) Fig. 38, right or lef t as nec -
essary to raise or lower t able stop (B).
3. Lower the t able and make cert ain the t able is
90 degrees to the blade as shown in Fig. 39.
4. It is necessary to remove the adjust able t able stop
(B) Fig. 38, when tilting the t able to the lef t.
TILTING THE TABLE
1. The t able on the band saw can be tilted 45 degrees
to the right and 10 degrees to the lef t. To tilt the t able to
the right, loosen two locking knobs (A) Fig. 37, tilt the
table to the desired angle as shown on scale (D), and
tighten two locking knobs (A).
2.To tilt the t able to the lef t, loosen two locking knobs
(A) Fig. 37, and tilt the t able slightly to the right until you
can gain access to t able stop (B) Fig. 38. Remove t able
stop (B) Fig. 38, and tilt the t able to the lef t angle up to
10 degrees and tighten two locking knobs (A) Fig. 37.
A
D
A
C
B
To Next Page
Loading...
