9
Fig. 17
Fig. 18
ASSEMBLING BELT
A N D PULLEY GUARD
Assemble belt and pulley guard (A) Fig. 17, to the top of
the st and and surrounding the driven pulley with two
3/4-20 x 5/8 hex head screws, flat washers and hex
nut s (B).
ASSEMBLING SWITCH
1. MAKE CERTAIN THE BAND SAW IS DISCON-
NECTED FROM THEPOWERSOURCE.
2. CAUTION: THE ON/OFF SWITCH-TO-MOTO R
CORD (F) FIG. 18, IS TIED TO VERTICAL MOUNTING
POST (G) OPPOSITE THE M O TO R PULLEY.THIS
CABLE TIE (H)PREVENTS THE SWITCH-TO-MOTO R
CORD(F), FROM CONTACTING THE BELT O R M O TO R
PULLEY DURING OPERATION. IMPORTA N T:D O N O T
REMOVE THIS CABLE TIE UNLESS Y O U A R E USING
THE ACCESSORY #28-984 HEIGHT ATTACHMENT
WITH THE BAND SAW .
3. Remove two outer hex nut s and lock washers (A)
Fig. 19, from the two screws extending out from the back
of the switch box (B).
4. Insert two screws (C) Fig. 19, located on back of
switch box, into two holes (D) located in the band saw
arm.
5. Fasten the switch box (B) to the band saw arm using
two hex nut s and lockwashers (A) Fig. 20, which were re-
moved in STEP 3.
Fig. 19 Fig. 20
B
A
C
D
A
B
To Next Page
Loading...
