6
Fig. 8
RAISING A N D LOWERING THE MOBILE BASE
1. To raise the mobile base (B) Fig. 8, and allow movement to a new location, push foot lever (A)
downward until the foot lever locks into position.
2. To lower the mobile base (B) Fig. 8, so it is supported by the floor surface, flip foot lever (A) upward.
3. IMPORTANT:TO AVOID PERSONAL INJURY, ALW AYS OPERATE THE MACHINE WITH THE
FOOT LEVER (A) IN THE RAISED POSITION A S SHOWNINFIG. 5.
B
A
ASSEMBLING THE BAND SAW
The st and is shipped top down inside the shipping cont ainer with the motor mounted to the inside top
of the st and. The on/of f switch is wired to the end of the power cord.
The motor must be removed from the inside top of the st and and reassembled to the horizont al mount -
ing bars inside the st and as follows:
1. Remove the stand (A) Fig. 9, from the shipping con -
tainer being careful not to crimp the switch cord which
extends through the top of the st and. NOTE: Set the
st and on several blocks of wood to raise the st and of f the
floor surface.
2. Remove panel (B) Fig. 9, from st and (A) by removing
two screws (C) and loosening two screws (D). Remove
p anel on opposite side of st and in the same manner.
Fig. 9
D
A
C
B
To Next Page
Loading...
