To Next PageTo Next Page
Need help?Do you have a question about the Delta 31-080 and is the answer not in the manual?
General| Type | Oscillating Spindle Sander |
|---|---|
| Oscillations Per Minute | 60 OPM |
| Spindle Sizes Included | 1/2 |
| Drum Speed | 1725 RPM |
| Spindle Speed | 1725 RPM |
Guidelines for grounding machines via cord to ensure operator safety.
Instructions for using adapters on circuits without proper grounding, with restrictions.
Introduction to the Delta Model 31-080 Belt/Disc Sander's features and intended use.
Procedures for safely removing the machine from packaging and performing initial cleaning.
Detailed guide for securely mounting the belt sander table using provided hardware.
Process for applying the abrasive disc to the sanding wheel for optimal adhesion.
Instructions for mounting the disc guard and its associated table assembly.
Critical steps to secure the sander to a stable surface to prevent movement.
How to safely operate the power switch to start and stop the sander.
Method for securing the switch in the OFF position to prevent unauthorized use.
Instructions for adjusting the belt tracking knob to ensure proper belt alignment.
How to set the belt table to a 90-degree angle relative to the sanding belt.
Procedures for adjusting the disc table's angle and position for sanding.
Instructions for adjusting or removing the platen for optimal work support.
Step-by-step guide for safely replacing the abrasive belt on the sander.
Instructions for removing and applying a new sanding disc to the unit.
