Need help?Do you have a question about the Delta 33-990 and is the answer not in the manual?
Read the manual to understand the tool's applications, limitations, and hazards before use.
Ensure all safety guards are in place and in proper working order during operation.
Always wear safety glasses for eye protection during operation.
Ensure the tool is properly grounded by using a three-prong plug and receptacle.
Always remove adjusting keys and wrenches before turning the tool on.
Disconnect tools from power before servicing or changing accessories.
Ensure the switch is OFF before plugging in the power cord to prevent accidental startup.
Never stand on the tool to avoid serious injury from tipping or contact with cutting tools.
Inspect for damaged parts before further use and repair or replace as needed.
Never leave the tool running unattended; always turn off the power.
Do not operate the tool under the influence of drugs, alcohol, or medication.
Ensure the tool is disconnected from power before mounting or connecting the motor.
Understand how to reduce kickback risk by using anti-kickback fingers and proper guard adjustment.
Always turn off power and wait for the blade to stop before moving workpiece or making adjustments.
Turn off the power and wait for the blade to completely stop before leaving the machine.
Disconnect the machine from the power source before servicing or changing blades.
Keep hands clear of the saw blade's path during operation.
Never reach around or behind the saw blade while it is in motion.
Helps prevent kickback during ripping by engaging the workpiece.
Step-by-step instructions for attaching the cuttinghead to the track arm.
How to level the saw using the leveling screws and lock nuts.
Emphasizes disconnecting power before starting adjustments.
Lowering the track arm to contact the table bracket for alignment.
Adjusting the table mounting brackets on both sides for proper alignment.
Describes the correct leveling procedure for the saw.
Information on proper electrical circuit requirements and connections.
Warning against using the tool in wet or damp conditions.
Crucial instructions for grounding the tool to prevent electric shock.
Specific instructions for operating the saw on 120-volt power.
Instructions for reconfiguring and operating the saw on 240-volt power.
Caution to ensure the receptacle is properly grounded.
Recommendation to lock the switch in the OFF position when not in use.
Critical warning to disconnect power before changing voltage connections.
Instructions for reconnecting motor leads according to nameplate instructions.
Requirement to replace the plug for 240-volt operation.
Explains the overload protection feature and how to reset it.
Procedure for adjusting ball bearings to eliminate play in the track arm.
How to adjust the tension of the elevating column for smooth operation.
Adjusting the tension of the track arm index for proper engagement.
Adjusting set screws to ensure the saw blade travel is square with the fence.
Emphasizes disconnecting power before starting adjustments.
Adjusting the bevel clamp lever and scale plate for blade squareness.
Emphasizes disconnecting power before starting adjustments.
Emphasizes disconnecting power before assembly.
Emphasizes the importance of a tight clamp knob for the blade guard.
Safety note to keep hands away from the guard during operation.
Safety instruction to shut off power before freeing a jammed guard.
Emphasizes disconnecting power before adjustments.
To Next Page
General
