To Next PageTo Next Page
Need help?Do you have a question about the Delta 33-892 and is the answer not in the manual?
General| Blade Diameter | 10 inches |
|---|---|
| Blade Size | 10 inches |
| No-Load Speed | 5000 rpm |
| Bevel Capacity | 0-45 degrees |
| Dust Port Size | 2.5 inches |
| Motor Power | 15 Amp |
| Arbor Size | 5/8 inch |
Defines safety symbols like DANGER, WARNING, and CAUTION for hazard recognition.
Provides fundamental safety precautions for operating the tool.
Explains proper grounding for electrical safety and shock prevention.
Explains the safety features of double-insulated tools and their plug requirements.
Details the use of polarized plugs for electrical safety and proper outlet connection.
Instructions for converting the saw from 120V to 240V operation.
Core safety advice including clothing, guards, tool care, and operation practices.
Mandates wearing safety glasses, hearing, and respiratory protection.
Rules for avoiding awkward positions, keeping hands clear, and using push sticks.
Defines key terms used in the manual like PUSH STICK and KICKBACK.
Explains how to avoid kickback and protect against injury.
Instructions for unpacking the machine and preparing surfaces for use.
Lists all parts included in the saw's packaging.
Step-by-step guide for attaching the machine's legs to the base assembly.
Instructions for installing the handle that controls the cuttinghead's vertical movement.
Procedure for connecting the cuttinghead assembly to the main track arm.
Instructions for models with magnetic starters, transformers, and overload protection.
Steps to ensure the track arm is parallel to table brackets for accurate cuts.
Continues adjustment of table brackets for track arm parallelism using feeler gauges.
Instructions for installing table clamps and rods to secure workpieces or fences.
Guide for installing the main table board and additional loose boards.
Procedure for mounting the saw blade and ensuring the blade guard is correctly fitted.
Safety warning before connecting power and checking power supply compatibility.
How to operate the on/off switch and safety precautions for plugging in.
Describes the function of the knob that controls track arm swing angle.
Explains the lever for positioning the yoke for ripping or cross-cutting.
Procedure to correct side motion in the overarm column due to wear.
How to adjust the yoke clamp handle for secure locking of the yoke.
Steps to adjust bearings for play between carriage and track rods.
Procedure for rotating track rods to compensate for wear and ensure smooth operation.
How to align the saw blade perpendicular to the table surface for accurate cuts.
Continues adjustment of blade squareness using bevel clamp and other controls.
How to adjust the track arm clamp handle for proper locking and unlocking of the arm.
Steps to ensure the saw blade travel is perpendicular to the fence for accurate cuts.
Continues adjustment for saw travel squareness to fence, addressing 'heeling'.
Procedure to check and correct 'heeling' where blade isn't square to fence.
How to install a stop to limit cutting-head travel for repetitive cross-cuts.
Instructions for adjusting the blade guard and anti-kickback rod for safety.
Instructions for installing a specific molding cutterhead guard accessory.
Detailed instructions and safety precautions for performing cross-cutting operations.
How to perform miter cuts, including angle settings and safety.
Instructions for performing compound miter cuts involving bevel and miter angles.
Explains the importance and use of push sticks for safe ripping operations.
Provides a pattern and instructions for building a push stick from wood.
Advice on cleaning the machine using compressed air and damp cloths.
Troubleshooting steps for when the machine fails to start.
Instructions for lubricating moving parts and surfaces.
Information on how to order identical replacement parts for the machine.
How to obtain free replacement warning labels if they are missing or illegible.
Guidance on obtaining service and repairs from authorized Delta centers.
Information about available accessories and safety warnings for non-Delta accessories.
Details the Two Year Limited New Product Warranty for the machine.
