Need help?Do you have a question about the Delta 34-444 and is the answer not in the manual?
General| Type | Table Saw |
|---|---|
| Motor Power | 1.5 HP |
| Bevel Range | 0 - 45 degrees |
| Blade Diameter | 10 inches |
| Table Size | 20 x 27 inches |
| Arbor Size | 5/8 inches |
Comprehensive safety guidelines covering tool operation, work area, personal protection, and maintenance.
Rules for safe operation of circular saws, including guard use, kickback avoidance, and feedstock.
Assemble the saw stand using carriage bolts, washers, and nuts.
Mount the saw onto the assembled stand using hex head screws and washers.
Position and secure the motor and mounting plate assembly to the saw using plungers.
Insert key, attach motor pulley, and align with arbor pulley for correct belt tension.
Mount the blade guard and splitter assembly between washer and bracket, securing with a screw.
Secure rear bracket, install blade, and check alignment of blade with splitter.
Proper electrical circuit requirements and guidance on selecting appropriate extension cords.
Ensure the 120V tool is grounded via its 3-conductor cord and plug to a proper receptacle.
Reconnect motor leads for 240V operation and use a compatible 240V plug and receptacle.
Understand overload protection and how to reset the motor after overload conditions.
To Next Page
