Need help?Do you have a question about the Delta 36-510 Type II and is the answer not in the manual?
General| Blade Size | 10 inches |
|---|---|
| Motor Power | 1.5 HP |
| Max Rip Capacity | 30 inches |
| Weight | 250 lbs |
| Arbor Size | 5/8 inches |
| Voltage | 120V |
| Amperage | 15A |
| Max. Rip Right of Blade | 30 inches |
| Table Size | 27 inches x 20 inches |
| Motor | 120V |
| Max Depth of Cut at 90 Degrees | 3-1/8 inches |
| Max Depth of Cut at 45 Degrees | 2-1/4 inches |
| Dust Port Size | 2.5 inches |
Steps to attach the handwheel handle for blade height adjustment.
Procedure for installing the blade guard and splitter assembly.
Details on electrical requirements and safe connection procedures.
Guidelines for selecting and using appropriate extension cords.
Technical specifications for the saw's motor.
How to safely turn the saw on and off using the main switch.
Method for locking the power switch to prevent accidental startup.
Explanation of the motor overload protection and reset procedure.
Instructions for adjusting the blade height using the handwheel.
Methods for tilting the saw blade to different angles.
Procedure for setting the positive stop for 90-degree blade alignment.
How to use and adjust the rip fence for accurate cuts.
Instructions for using and adjusting the miter gage for cross-cutting.
Steps to ensure the saw blade is parallel to the miter gage slots.
Detailed instructions for safely replacing the saw blade.
Technique for performing cross-cuts using the miter gage.
Technique for performing rip cuts using the rip fence.
How to add wood facing to the rip fence for specific operations.
Instructions for building a featherboard for improved workpiece control.
Guide to making a push stick for safe feeding of narrow stock.
To Next Page
