To Next PageTo Next PageWhat to do if my Delta 36-5100 T2 fails to start?
If your Delta Saw fails to start, make sure the prongs on the cord plug are making good contact in the receptacle, and check the reset button on the power switch housing. Also, check for blown fuses or open circuit breakers in your power line.
General| Type | Table Saw |
|---|---|
| Motor Power | 1.5 HP |
| Blade Diameter | 10 inches |
| Table Size | 40 inches x 27 inches |
| Weight | 250 lbs |
| Voltage | 120 V |
| Amperage | 15A |
| Max Rip Left | 12 inches |
| Arbor Size | 5/8 inches |
| Max Rip Right | 30 inches |
| Max Depth of Cut at 90 Degrees | 2.25 inches |
| Max Depth of Cut at 45 Degrees | 2-1/4 in |
| Motor | Induction Motor |
Explains the meaning of various safety symbols and warnings used in the manual.
Provides essential safety guidelines for operating any power tool safely.
Outlines critical safety precautions specific to operating a table saw.
Explains the function and importance of safety guarding systems for kickback prevention.
Describes the causes of kickback and methods to prevent this dangerous occurrence.
Calibrates bevel stops and aligns the riving knife with the blade for precision.
Essential pre-use checks and critical advice on preventing kickback.
Procedures for Rip Cuts, Crosscuts, Bevel Cuts, and other common operations.
