FRONT AND REAR RAILS
Hardware Bag “C, D”
1. Using the supplied 3/16 inch T-Handle Allen Wrench, attach
the Front Rail
PC18
[1] to the table front with two 5/16-18 x
1 1/8 inch Flat Countersunk Hex Screw
HP15
and two 5/16-
18 Hex Flange Nuts
HP14
. See Figure 5.
2. Using the supplied 3/16 inch T-Handle Allen Wrench, attach
the Rear Rail
PC17
[2] to the table back using two 5/16-18 x
7/8 inch Hex Screw with Split Lock Washer
HP7
. See Figure
7.
NOTE: Use the two aligning holes which are spaced 16 inch apart
to align the front and rear rails to the table aligning holes which
are also spaced 16 inch apart.
3. Use supplied Rail Alignment Gauge
HP20
to ensure the rail is
the proper distance from the top of the table at each side
of the cast iron table. See Figure 6.
Figure 5
Figure 6
Figure 7
ASSEMBLY
1
2
Front RailFront Rail
Rear Rail
FRONT
BACK
HP15
HP7
HP14
HP14
PC20
18
To Next Page
Loading...
