To Next PageTo Next PageHow to troubleshoot a Delta Saw that is not starting?
To troubleshoot a Delta Saw that fails to start: * Ensure the cord plug prongs are making good contact in the receptacle. * Check the reset button on the power switch housing. * Inspect your power line for blown fuses or open circuit breakers.
General| Motor Power | 1.75 HP |
|---|---|
| Blade Diameter | 10 inches |
| Voltage | 120 V |
| Dust Port | 2.5 inches |
| Rip Capacity | 30 inches |
| Arbor Size | 5/8 inches |
| Max Rip Left | 15 inches |
| Motor | 15 Amp |
| Max Cut at 90° | 3.5 inches |
| Max Cut at 45° | 2.25 inches |
Explains safety alert symbols and their meanings for safe operation.
Focuses on the importance of using and maintaining blade guards and related safety devices.
Details safe practices and warnings for various cutting operations.
Describes what kickbacks are and how to prevent them.
Describes the initial setup of the saw blade and riving knife.
Instructions for installing and removing the blade guard assembly.
Details how to check and adjust the bevel angle stops for accuracy.
Steps to verify the riving knife's alignment with the saw blade.
Steps to ensure the fence is square to the table.
Instructions for adjusting the blade height relative to the workpiece.
Explains how to adjust the riving knife's height for different cuts.
Instructions for ensuring the blade is parallel to the miter gauge slot.
Details how to adjust blade parallelism.
How to verify the rip fence is properly aligned.
Explains kickback and how to prevent it.
