Delta 36-725 T2 - Installing the Handles; Installing the Rip Fence Handle

18
Figure 17
Figure 18
The elevation and Bevel Handles are packaged together in the box,
please install as follows:
1. Insert one Handle
PC14
to the Elevation Hand Wheel located
in the front of the Saw, as seen in Figure 17.
2. Insert one Handle
PC14
to the Bevel Hand Wheel located on
the right side of the Saw, as seen in Figure 18.
The Rip Fence Handle is packaged individually and labeled
accordingly, please install as follows:
1. Screw the Labeled Handle
PC15
to the Rip Fence with the
supplied Hex Wrench. See in Figure 18.
IMPORTANT: Before raising Blade you MUST release Bevel
Lock and tilt Blade 45° and remove styrofoam block under Motor
Housing. See Figure 19.
PC14
PC14
PC15
INSTALLING THE HANDLES
Elevation and Bevel Hand Wheels
INSTALLING THE RIP FENCE
HANDLE
ASSEMBLY
Figure 19
(REMOVE)(REMOVE)