24
Figure 31
Figure 32
Figure 33
A
B
C
ADJUSTING THE MITER GAUGE
FITMENT
To adjust the tment between the miter gauge bar and the miter
slot:
1. Use a 3/32 inch Allen wrench on any of the three set
screws located on the side of the bar. See Figure 32 and
33.
2. To remove any side-to-side movement between the miter
gauge bar and miter gauge table slot adjust the three small
set screws found along the length of the miter gauge bar.
NOTE: The set screws should extend just beyond the side of the
bar.
ADJUSTING THE MITER GAUGE
SCALE
1. Use the supplied 3/16 inch two-way Allen wrench to loosen
the three Phillip screws located in the back of the miter
gauge, see in Figure 31
A
.
2. Loosen the knob, see in Figure 31
B
.
3. Adjust the detent plate so that the indicator measures the
correct angle, see in Figure 31
C
.
4. Once lined up, re-tighten the knob, and Phillip screws back
in place.
NOTE: Use a combination square to check bar to head angle. If
miter gauge bar is not square to miter gauge head, then adjustment
is necessary.
MAKING ADJUSTMENTS
To Next Page
Loading...
