To Next PageTo Next Page
Need help?Do you have a question about the Delta 36-560 and is the answer not in the manual?
General| Type | Table Saw |
|---|---|
| Blade Diameter | 10 inches |
| Motor Power | 1.5 HP |
| Table Size | 40 x 27 inches |
| Weight | 300 lbs |
| Arbor Size | 5/8 inches |
| Max. Rip Left of Blade | 12 inches |
| Max. Depth of Cut at 90 Degrees | 3-1/8 inches |
| Max. Depth of Cut at 45 Degrees | 2-1/4 inches |
| Motor | Induction |
| Voltage | 120/240 V |
| Amperage | 15A |
| Max. Rip Right of Blade | 30 in |
| Rip Capacity | 30 inches |
Essential practices for safe tool operation and maintenance.
Precautions for operator well-being and workspace conditions.
Maintaining focus, checking machine integrity, and preventing unintended starts.
Essential measures to prevent kickback and use of safety guards.
Guidelines for proper workpiece handling and body positioning.
Procedures for initial setup, tool maintenance, and securing the machine.
Details on electrical circuit requirements and motor specifications.
Essential guidelines for proper machine grounding to prevent electric shock.
Table showing recommended extension cord gauges based on ampere rating and length.
Introduction to the table saw and steps for unpacking and cleaning.
Diagram and list of key components of the table saw.
List and diagram of parts for assembling the Model 36-560 stand.
Step-by-step instructions for assembling the blade raising and lowering handwheel.
Instructions for assembling the blade guard and splitter for kickback prevention.
Attaching the extension wing and mounting the guide rail.
Steps for assembling and installing the rip fence onto the table saw.
Instructions for assembling the miter gage holder to the saw cabinet.
Steps for assembling and mounting the outfeed support.
Assembling the stand and securely mounting the saw to a surface.
Instructions for turning the table saw on and off.
Procedure for securing the switch in the 'OFF' position to prevent unauthorized use.
Explanation of the overload relay and how to reset it.
How to use the handwheel to adjust the blade height.
Instructions for tilting the saw blade to desired angles.
Guide to setting accurate positive stops for blade angles.
How to move, lock, and adjust the rip fence for accurate cuts.
Procedure to ensure the rip fence is parallel to the miter gage slot.
Guidelines for using the miter gage for cross-cutting operations.
How to adjust the miter gage's index stops for 90 and 45 degree angles.
Procedure to ensure the saw blade is parallel to the miter gage slots.
Step-by-step guide on how to safely replace the table saw blade.
How to perform cross-cuts using the miter gage and saw guard.
Instructions for performing rip cuts using the rip fence and guard.
Guidance on using push sticks for narrow work and pushboards.
How to add wood facing to the rip fence for specific operations.
Dimensions and instructions for making a featherboard.
Pattern and material recommendations for constructing a push stick.
Information on obtaining a complete line of accessories.
Contact information for parts, service, and warranty support.
Details of the Delta two-year limited warranty for machines and accessories.
