v1.0.0
31
4 Operation
Turn on the upstream breaker. The indicator flashes in yellow during a system self-test. After the self-test
completed, the indicator illuminates in blue and the EVSE is ready to charge.
4.1 Start charging
1. Connect the vehicle connector to vehicle inlet.
Note: for socket or socket with shutter model, please connect the plug to EVSE first.
2. Place the RFID card over the sensor area to initiate the charging process.
Note:
a. Successful card detection is indicated by two short beeps. A long beeping sound indicates authentication
failure. Please check your card and try it again.
b. The EVSE returns to standby mode if the vehicle connector is not connected to the EV within 60 seconds
after card authentication.
3. The indicator flashes blue to indicate the charging is initiated.
4.2 Stop charging
1. Stop charging session at the vehicle or swipe the RFID card again to stop the charging process.
2. Disconnect the vehicle connector from the vehicle inlet.
Note: the plug would be locked by the EV and please unlock the plug if needed.
3. Recover the vehicle connector to vehicle connector inlet.
5 LED Indicator
Status Description
Black Power off.
Yellow, fast flashing Initial configuration and self-test.
Blue Standby mode (not connecting to EV).
Yellow Ready to charge (connecting to EV).
Blue, slow flashing Charging in progress.
Green Charging process completed or network connection success.
Yellow, 1 Flash Network connection fail
Yellow, slow flashing Limited output power by active power control or OCPP command
Red, slow flashing Refer to fault event.
Red Failed self-test, general malfunction
To Next Page
Loading...
