Delta Amplon RT Series User Manual

Amplon RT Series 95
10.2 Main Menu
In the Main Screen, press the Enter button ( ) for 0.1 second to enter the Main Menu where
you can view or set up relevant items.
NOTE:
Please note that only qualified service personnel can perform the setup.
For setup procedures, please refer to the following:
1. In the
Main Menu
, select the item you want to configure and press the Enter button ( ) for 0.1
second. After that, the UPS will enter the setting mode.
2. Press the Scrolling Up or Down button ( / ) for 0.1 second to navigate the setting items.
3. Press the Enter button ( ) for 0.1 second to choose the parameter that you want to change,
and the parameter will flash.
4. Press the Scrolling Up or Down button ( / ) for 0.1 second to increase or decrease the
parameter value. If either of the buttons is pressed for over 2 seconds, the LCD will automatically
increase or decrease by the selectable value every 0.2 second until the button is released or the
parameter reaches its highest or lowest value.
5. Press the Enter button ( ) to confirm your parameter setting.
6. Press the Scrolling Up or Down button ( / ) for 0.1 second to move to the previous or the
next setting item.
7. If you press the ESC button ( ), the LCD will exit the setting mode. If you do not press any
button for more than 5 minutes, the LCD will exit the setting mode and go back to the original
display automatically.
Please refer to
Figure 10-1
below for all the setup items.

Delta Amplon RT Series Specifications

General

Brand	Delta
Model	Amplon RT Series
Category	UPS
Language	English