Delta ASD-M-1521 Series - Page 389

Chapter 8 Parameters ASDA-M
8-158 Revision December, 2014
Data Size：
16bit
Format：
DEC
Settings：
Please refer to P5-20 for the setting of acceleration/deceleration
time in PR mode.
P5-33 AC13
Acceleration/Deceleration Time
(Number #13)
Address: 0542H
0543H
Parameter
Attribute：
Parameter for individual axis
Related Section:
Section 7.10
Operational
Interface：
Panel / Software Communication
Default：
8000
Control
Mode：
PR
Unit：
ms
Range：
1 ~ 65500
Data Size：
16bit
Format：
DEC
Settings：
Please refer to P5-20 for the setting of acceleration/deceleration
time in PR mode.
P5-34 AC14
Acceleration/Deceleration Time
(Number #14)
Address: 0544H
0545H
Parameter
Attribute：
Parameter for individual axis
Related Section:
Section 7.10
Operational
Interface：
Panel / Software Communication
Default：
50
Control
Mode：
PR
Unit：
ms
Range：
1 ~ 65500
Data Size：
16bit
Format：
DEC
Settings：
The default value of this parameter is smaller (short deceleration
time) and it is used for deceleration time setting of auto protection.