ASDA-A2 Chapter 8 Parameters
Revision February, 2017 8-13
8.3 Parameter Description
P0-xx Monitor Parameters
P0-00★
VER Firmware Version
Address: 0000H
0001H
Operational
Interface：
Panel / Software Communication
Related Section: -
Default：
Factory Setting
Control
Mode：
ALL
Unit：
-
Range：
-
Data Size：
16-bit
Format：
Decimal
Settings：
This parameter shows the firmware version of the servo drive.
P0-01■
ALE
Alarm Code Display of Drive (Seven-segment
Display)
Address: 0002H
0003H
Operational
Interface：
Panel / Software Communication
Related Section:
11.1, 11.2, 11.3
Default：
-
Control
Mode：
ALL
Unit：
-
Range：
0x0000~0xFFFF: It only can be set to 0 to
clear the alarm (Same as DI.ARST).
Data Size：
16-bit
Format：
BCD
Settings：
Hexadecimal format: displays the alarm code
To Next Page
Loading...
