Delta ECMA-E 1315 Series User Manual

Chapter 8 Parameters ASDA-A2
8-154 Revision February, 2017
P4-12 SOF2 Analog Speed Input Offset Adjustment 2
Address: 0418H
0419H
Operational
Interface：
Panel / Software Communication
Related Section: -
Default：
Factory default
Control
Mode：
ALL
Unit：
-
Range：
0 ~ 32767
Data Size：
16-bit
Format：
Decimal
Settings：
Manually adjust the hardware offset. The adjustment function needs to
be enabled by the setting of parameter P2-08. It is not suggested to
adjust the auxiliary adjustment. This parameter cannot be reset.
P4-13 TOF1 Analog Torque Input Offset Adjustment 1
Address: 041AH
041BH
Operational
Interface：
Panel / Software Communication
Related Section: -
Default：
Factory default
Control
Mode：
ALL
Unit：
-
Range：
0 ~ 32767
Data Size：
16-bit
Format：
Decimal
Settings：
Manually adjust the hardware offset. The adjustment function needs to
be enabled by the setting of parameter P2-08. It is not suggested to
adjust the auxiliary adjustment. This parameter cannot be reset.

Delta ECMA-E 1315 Series Specifications

General

Brand	Delta
Model	ECMA-E 1315 Series
Category	Servo Drives
Language	English