Note:
The hole diameter on the cement base of the expansion tube is 20 mm (0.79").
4.
First insert a washer in the anchoring bolt followed by a nut.
5.
Turn the nut until it is lowered in the bolt. Do not tighten at this time. All nuts must be inserted in
their respective anchoring bolts.
6.
Repeat for the remaining anchoring bolts.
7.
Once all nuts are inserted, tighten the anchoring bolts in an ascending order. See the following
figure.
8.
Move on to the opposite side of the bolt and tighten the bolt.
9.
Repeat in the same manner for the remaining anchoring bolts.
Figure 37. Securing a Cabinet with Anchoring Bolts
To Next Page
Loading...
