Wiring
General Introduction
For wiring convenience, you can lead the cables and wires from the left, right, front or rear bottom side
of the unit into the cabinet.
The following sections will be described in the case of wiring from the front bottom side of the unit as an
example. As for the other cases, please remove the relevant side cover of the unit base to lead the
cables and wires into the cabinet.
To do the wiring works from the front bottom side of the PCS, first remove the front cover of the unit
base and the protective cover in the middle of the cabinet and with a Phillips screwdriver.
Figure 55. Remove the Front Cover of the Unit Base and the Protective Cover
Inside the PCS cabinet, you will see several cable glands for DC, AC and communication wiring on the
bottom of the cabinet as shown below:
Figure 56. AC, DC, and Communication Wiring Cable Glands
To Next Page
Loading...
