5.
Install the plexiglass cover and secure the nuts.
Figure 69. Installing the Plexiglass Cover
After finishing all the wiring works, reinstall the protective cover, close and lock the front door.
Note:
Make sure all wirings are secured.
After wiring, the protective cover must be installed and can not be energized without
protective covers.
Wiring need to be fixed firmly.
Two-hole terminals must be wrapped with thermoplastic sleeves or insulating sleeves to
avoid potential safety hazards.
During the installation process, the disassembled items are placed centrally to avoid loss.
To Next Page
Loading...
