Need help?Do you have a question about the Delta RT-31 and is the answer not in the manual?
Assemble the blade raising and tilting handles onto the saw's handwheels.
Attach the extension wing to the left side of the saw table.
Install the primary saw blade onto the arbor.
Install the scoring blade onto the arbor.
Assemble the splitter, table insert, and blade guard.
Construct the Unifence table using specified materials and dimensions.
Assemble the stop rod assembly into the miter gage body.
Adjust mechanisms for saw blade height and angle.
Adjust 90° and 45° positive stops for precise blade angles.
Align the scoring blade with the main saw blade.
Adjust fence parallelism and locking handle action.
Adjust miter gage angles and stop rod positions.
Set the correct tension for the V-belts.
Adjust scoring drive belt tension and tracking.
Remove end play from elevating and bevel shafts.
Adjust blade stops and describe the chip exhaust chute.
Operate start/stop switch and understand overload protection.
Reposition the fence for ripping operations on the left side.
Utilize the Unifence as a cut-off gage for consistent crosscutting.
Use the miter gage and adjustable stop rods for crosscutting.
Assemble the miter gage support extension for larger workpieces.
Utilize the built-in accessory storage tray.
Modify the side plate cover to accommodate dado blades.
Install dado cutter sets onto the saw arbor.
To Next Page
General
