EXTENSION CORDS
Use proper extension cords. Make sure your extension cord is in good condition and is a 3-wire extension cord which
has a 3-prong grounding type plug and matching receptacle which wiii accept the machine's plug. When using an
extension cord, be sure to use one heavy enough to carry the current of the machine. An undersized cord will cause
a drop in line voltage, resulting in loss of power and overheating. Fig. C shows the correct gauge to use depending on
the cord length. If in doubt, use the next heavier gauge. The smaller the gauge number, the heavier the cord.
MINmMUM GAUGE EXTENSmON CORD
RECOMMENDED SIZES FOR USE WiTH STA31ONARY ELECTRI© MACHINES
Ampere Total Length
Rating Volts of Cord in Feet
0=6 i 20 up to 25
0=6 120 25-50
0=6 i20 50-100
0=6 i20 100-150
6=10 120 up to 25
6=10 120 25-50
6=i0 i20 50-i00
6=i0 i20 i00=i50
i0=12 i20 up to 25
i0=12 i20 25=50
I0=12 i20 50=I00
i0=i2 i20 i00=i50
i2=i6 i20 up to 25
i2=i6 i20 25=50
i2=i6 i20
Gauge of
Extension Cord
i8 AWG
i6 AWG
i6 AWG
i4 AWG
i8 AWG
16 AWG
i4 AWG
i2 AWG
i6 AWG
i6 AWG
i4 AWG
i2 AWG
i4 AWG
i2 AWG
GREATER THAN 50 FEET NOT RECOMMENDED
Fig. C
NG INSTR
Delta Model MS350 is a 10" Compound Power Miter Saw designed to cut wood, plastic, and aluminum. Compound
angle and bevel cutting are easy and accurate. It can crosscut up to 5-3/4" x 2-3/8"at the 90 degree position, miter at
45 degrees, both left and right 4-1/8" x 2-3/8", bevel at 45 degrees left 5-1/2" x 1-9/16", and compound 45 x 45 degrees
4-1/8" x 1-9/16". It has positive miter stops at 0, 22.5, 31.62, and 45 degrees both ieft and right, and bevel stops at 0
and 45 degrees adjustable.
UNPACKING AND CLEANING
Carefully unpack the machine and all loose items from the shipping container(s). Remove the protective coating from
all unpainted surfaces. This coating may be removed with a soft cloth moistened with kerosene (do not use acetone,
gasoline or lacquer thinner for this purpose). After cleaning, cover the unpainted surfaces with a good quality household
floor paste wax.
To Next Page
Loading...
