TP70P-211LC1T/TP04P-20EXL1T Operation Manual
3-8
(3) Unstable
When the weight value is not stable, the Unstable in the bulletin is highlighted in a red block. When the weight value
is stable, the Motion in the bulletin is highlighted in a green block.
(4) Cal. Issue
When an error occurs, for example, putting a higher value for a lighter weight, even if the calibration is done, the Cal.
Issue in the bulletin is highlighted in a red block. When this warning appears, the weight value is not reliable.
(5) Overflow
After calculation, the load weight on the weighing platform converts to a digital value. If the digital value exceeds the
maximum allowable number, the Overflow in the bulletin is highlighted in a red block.
(6) Max
You can set up a weight maximum limit in the Load Cell Setup page. When the weight used exceeds the maximum
limit, the Max in the bulletin is highlighted in a red block.
(7) Power
When the power supply is abnormal, the Power in the bulletin is highlighted in a red block.
(8) Zero Reset
Reset the present value to zero.
(9) Unit Setup
Here you can select the weight unit, in kilogram or in gram.
To Next Page
Loading...
Need help?
General
