Delta VFD-ED Series

Chapter 11 Summary of Parameter Settings | VFD-ED
11-13
03 Analog Input / Output Parameters
Pr. Parameter Name Setting Range Default
VF
VFPG
SVC
FOCPG
FOCPM

03-00
Analog Input 1 (AUI1)
0: No function
1
○
○
○
○
○
03-01 Reserved
1: Frequency command (speed limit under
torque control mode)
 03-02
Analog Input 2 (AUI2)
2: Torque command (torque limit under
speed mode)
0
3: Load compensation
○
○
○
○
○
4–5: Reserved
6: P.T.C. thermistor input value
○
○
○
○
○
7: Positive torque limit
○
○
8: Negative torque limit
○
○
9: Regenerative torque limit
○
○
10: Positive/negative torque limit
○
○
 03-03
Analog Input Bias 1
(AUI1)
-100.0–100.0% 0.0 ○ ○ ○ ○ ○
03-04
Reserved
 03-05
Analog Input Bias 1
(AUI2)
-100.0–100.0% 0.0 ○ ○ ○ ○ ○
 03-06
AUI1
Positive/negative Bias
Mode
0: Zero bias
1: Lower than or equal to bias
2: Higher than or equal to bias
3: Using bias as the base to get the
absolute value of bias voltage (unipolar)
4: Using bias as the base (unipolar)
0 ○
○ ○ ○ ○
03-07
Reserved
 03-08
AUI2
Positive/negative Bias
Mode
0 ○ ○ ○ ○ ○
 03-09
Analog Input Gain 1
(AUI1)
0.0–500.0% 100.0 ○ ○ ○ ○ ○
03-10
Reserved
 03-11
Analog Input Gain 1
(AUI2)
0.0–500.0% 100.0 ○ ○ ○ ○ ○
 03-12
Analog Input Filter
Time (AUI1)
0.00–2.00 sec. 0.01 ○ ○ ○ ○ ○
03-13
Reserved
 03-14
Analog Input Filter
Time (AUI2)
0.00–2.00 sec. 0.01 ○ ○ ○ ○ ○
03-15
Load Compensation
Auto-tuning
0: No function
1: Auto-tunes with running without load
2: Auto-tunes with running with load
0 ○ ○ ○ ○ ○
03-15
Reserved
03-16
Reserved
 03-17
Analog Output
Selection 1
0: Output frequency (Hz)
0
○
○
○
○
○
1: Frequency command (Hz)
○
○
○
○
○
2: Motor speed (RPM)
○
○
○
○
○
3: Output current (rms)
○
○
○
○
○
4: Output voltage
○
○
○
○
○