Delta VFD-ED Series

12 Descriptions of Parameter Settings | VFD-ED
12-06-21
12: Low voltage during deceleration (Lvd)
13: Low voltage during constant speed (Lvn)
14: Low voltage at stop (LvS)
15: Input Phase loss (PHL)
 A minimum time interval between retries is 5.5 seconds when OCx/GFF faults are triggered.
Frequency Command when the Most Recent Fault Occurred
Control Mode VF VFPG SVC FOCPG FOCPM Default: Read only
Settings 0.00–655.35 Hz
Output Frequency when the Most Recent Fault Occurred
Control Mode VF VFPG SVC FOCPG FOCPM Default: Read only
Settings 0.00–655.35 Hz
Output Current when the Most Recent Fault Occurred
Control Mode VF VFPG SVC FOCPG FOCPM Default: Read only
Settings 0.00–655.35 Amps
Motor Frequency when the Most Recent Fault Occurred
Control Mode VF VFPG SVC FOCPG FOCPM Default: Read only
Settings 0.00–655.35 Hz
Output Voltage when the Most Recent Fault Occurred
Control Mode VF VFPG SVC FOCPG FOCPM Default: Read only
Settings 0.0–6553.5 V
DC Bus Voltage when the Most Recent Fault Occurred
Control Mode VF VFPG SVC FOCPG FOCPM Default: Read only
Settings 0.0–6553.5 V
Output Power when the Most Recent Fault Occurred
Control Mode VF VFPG SVC FOCPG FOCPM Default: Read only
Settings 0.0–6553.5 kW
Output Torque when the Most Recent Fault Occurred
Control Mode VF VFPG SVC FOCPG FOCPM Default: Read only
DC Breaking
Malfunction
Pr06-52
Time interval of ttempting to econnect while malfunction
ar
Pr02-11~Pr02-16: MO #46: Malfunction Indication
RUN command (forward/reversly)
MI1 =40: Enable the motor drive
MO#12: Release the mechnical brake
MO #46: Attempting to reconnect while malfunction
Auto Reset-
DC Breaking