Delta VFD25AMS43AFSHA

Chapter 12 Description of Parameter SettingsMS300 (High Speed Model)
12-06-9
33: U-phase current detection error (cd1)
34: V-phase current detection error (cd2)
35: W-phase current detection error (cd3)
36: Clamp current detection error (Hd0)
37: Over-current detection error (Hd1)
. 48: Analog current input loss (ACE)
49: External fault input (EF)
50: Emergency stop (EF1)
51: External base block (bb)
52: Password error (Pcod)
54: Communication error (CE1)
55: Communication error (CE2)
56: Communication error (CE3)
57: Communication error (CE4)
58: Communication time-out (CE10)
61: Y-connection / ᇞ-connection switch error (ydc)
62: Decel. energy backup error (dEb)
72: Channel 1 (S1~DCM) safety loop error (STL1)
76: Safe torque off (STo)
77: Channel 2 (S2~DCM) safety loop error (STL2)
78: Internal loop error (STL3)
79: U phase over current before run (Aoc)
80: V phase over current before run (boc)
81: W phase over current before run (coc)
82:
U phase output phase loss (oPL1)
83: V phase output phase loss (oPL2)
84: W phase output phase loss (oPL3)
87: Drive over load in low frequency (oL3)
101: CANopen software disconnect 1 (CGdE)
102: CANopen software disconnect 2 (CHbE)
104: CANopen hardware disconnect (CbFE)
105: CANopen index setting error (CIdE)
106: CANopen station number setting error (CAdE)
107: CANopen memory error (CFrE)
121:
Internal communication error (CP20)
123:
Internal communication error (CP22)
124: Internal communication error (CP30)
126: Internal communication error (CP32)
127:
Software version error (CP33)
128: Over-torque 3 (ot3)
129: Over-torque 4 (ot4)
134: Electronics thermal relay 3 protection (EoL3)