To Next PageTo Next Page
Need help?Do you have a question about the Delta VFD9A0MS43ANSHA and is the answer not in the manual?
General| Brand | Delta |
|---|---|
| Model | VFD9A0MS43ANSHA |
| Category | Controller |
| Language | English |
Details about drive nameplate information for identification and verification after unpacking.
Specifies required clearances around the drive for proper airflow and installation to prevent overheating.
Covers essential wiring precautions and guidelines to ensure safe and correct installation of the AC motor drive.
Illustrates the overall system wiring diagram, detailing connections for power input, reactors, and motors.
Presents the main circuit diagram, illustrating the connections for power input, DC reactor, and motor.
Details the specifications and dimensions of ring lugs required for main circuit terminal connections.
Explains the characteristics and wiring of analog input terminals, including shielded wiring and twisted-pair usage.
Describes the different modes (Sink/Source) for contact input terminals and their wiring configurations.
Provides a step-by-step guide on how to install optional cards into the MS300 drive, including handling precautions.
Provides detailed specifications for the 230V series of MS300 drives, including 1-phase and 3-phase models.
Details the specifications for the 460V series of MS300 drives, covering both built-in filter and non-filter models.
Summarizes drive parameters, including identity codes, rated current, and parameter reset options for the MS300 drive.
Lists basic parameters related to motor operation, including frequency, voltage, acceleration, and deceleration times.
Details parameters for configuring digital inputs and outputs, including multi-function input/output command settings.
Covers parameters for analog input and output selection, gain, bias, and filter time settings.
Lists protection parameters such as low voltage level, over-voltage stall prevention, and over-current stall prevention.
Lists additional protection parameters, including fault records, over-torque detection, and electronic thermal relay settings.
Details error codes displayed on the keypad, their descriptions, and recommended corrective actions for MS300 drives.
Provides a list of PLC error codes (PLod, PLSv, PLdA, etc.) and their recommended handling approaches for troubleshooting.
Introduces the MS300's Safe Torque Off (STO) function, explaining its purpose and compliance with international specifications.
Describes the STO related terminal functions, including input voltage, current, and activation/cut-off modes.
Provides wiring diagrams for the safe control loop, including internal circuits and external connections for STO function.
Lists STO relevant error codes (72, 76, 77, 78) and provides troubleshooting instructions for each.
Guides the user through steps to check the normality of STO and related detection functions after wiring.
