Need help?Do you have a question about the Delta VFD-M-D series and is the answer not in the manual?
General| Series | VFD-M-D |
|---|---|
| Control Mode | V/F control, Sensorless Vector Control (SVC) |
| Enclosure Rating | IP20 |
| Output Frequency | 0.1-400Hz |
| Overload Capacity | 150% for 60 seconds |
| Braking Unit | Built-in |
| Communication | RS-485 |
| Protection | Overvoltage, Undervoltage, Overcurrent, Overload, Short Circuit, Ground Fault, Overheating |
| Operating Temperature | -10°C to +50°C |
| Storage Temperature | -20°C |
| Ambient Humidity | 90% RH or less (non-condensing) |
| Cooling Method | Fan Cooling |
Procedures for checking the AC motor drive upon receipt.
Steps to prepare the drive before installation and wiring.
Important warnings regarding component handling and testing.
Precautions to avoid damage or injury during operation and installation.
Recommended environmental conditions for operating the AC motor drive.
Instructions for physically mounting and installing the AC motor drive.
General information and precautions for wiring the AC motor drive.
Fundamental wiring procedures and safety guidelines for the drive.
Detailed explanation of connections for the main power and control terminals.
Functions and wiring of digital and analog control terminals.
Specifications and connection details for main circuit power terminals.
Essential checks and preparations before powering on the AC motor drive.
Steps and checks for performing an initial trial run of the drive.
Step-by-step guide on using the keypad for parameter settings and operation.
Detailed explanations for each parameter group and its individual parameters.
Parameters for drive protection, fault handling, and special features.
Troubleshooting guide for common fault codes and their corrective actions.
Methods for resetting the AC motor drive after resolving a fault.
Diagnostic flowchart for resolving over-current faults.
Troubleshooting steps for ground fault issues.
Diagnostic flowchart for over-voltage conditions.
Troubleshooting steps for low-voltage conditions.
Steps to diagnose and resolve overheating issues.
Troubleshooting guide for overload conditions.
Troubleshooting steps for phase loss faults.
Diagnostic flowchart for troubleshooting when the motor fails to run.
Steps to diagnose and fix motor stalling during acceleration.
Recommended schedule and procedures for periodic maintenance.
Critical safety warnings for maintenance procedures.
Detailed schedule and methods for periodical maintenance tasks.
To Next Page