Delta VFD-M-D series

Chapter 4 Digital Keypad Operation|VFD-M-D Series
4-2 Revision Jan. 2007, MDE2, SW V1.05
Display Message Descriptions
Displays the actual stored value of the selected parameter.
External Fault.
Display “End” for approximately 1 second if input has been accepted.
Display “Err”, if the input is invalid.
4.2 How to Operate the Digital Keypad LC-M2E
or
or
or
or
or
or
or
or
To set parameters
to set the parameters.
to return to the selection mode.
NOTE: In the parameter setting mode, you can press
move to previous
display
parameter set
successfully
parameter set
error
畫面選擇畫面選擇畫面選擇 Selection mode
NOTE: In the selection mode, press
START
資料修改
轉向設定
GO START
START
MODE MODE
MODE
MODEMODE
ENTER
MODE
ENTER ENTER
ENTER
MODE
or
START
資料修改
轉向設定
GO START
START
MODE MODE
MODE
MODEMODE
ENTER
MODE
ENTER ENTER
ENTER
MODE
or
START
資料修改
轉向設定
GO START
START
MODE MODE
MODE
MODEMODE
ENTER
MODE
ENTER ENTER
ENTER
MODE
or
START
GO START
START
MODE MODE
MODE
MODEMODE
ENTER
MODE
ENTER ENTER
ENTER
MODE
or
To modify data
To set direction