Chapter 5 Parameters|VFD-M-D Series
Revision Jan. 2007, MDE2, SW V1.05 5-71
18 Motor over load (oL2)
19 Reserved
20 Software/password protection (PcdE/Ccde)
21 Reserved
22 Reserved
23 Reserved
24 Reserved
25 Reserved
26 PG feedback signal error (PGEr)
27 Door open/close complete signal error (PSEr)
28 Door open time-out (doEr)
35 Communication time-out (CE10)
In Pr.7-15 to Pr.7-18 the four most recent faults that occurred, are stored. After removing the
cause of the fault, use the reset command to reset the drive.
7 - 19 Accumulative Motor Operation Time (Min.) Unit: 1
Settings 00 to 1439 min Factory Setting: 00
7 - 20 Accumulative Motor Operation Day Unit: 1
Settings 00 to 9999 day Factory Setting: 00
Pr.7-19 and Pr.7-20 are used to record the motor operation time. They can be cleared by
setting to 00 and time is less than 60 seconds is not recorded.
To Next Page
Loading...
