Chapter 11 Summary of Parameter SettingsMS300 (High Speed Model)
11-32
Pr. Explanation Settings
Factory
Setting
09-91
Additional setting for
communication card
bit 0: Enable IP filter
bit 1: Internet parameters enable (1 bit)
When IP address is set up, this bit will be
enabled. After updating the parameters of
communication card, this bit will change to
disable.
bit 2: Login password enable (1 bit)
When enter login password, this bit will be
enabled. After updating the parameters of
communication card, this bit will change to
disable.
0
09-92
Status of communication card
bit 0: Password enable
When the communication card is set with
password, this bit will be enabled. When the
password is clear, this bit will be disabled.
0
To Next Page
Loading...
