DEMA D6B Series - Communication Function Parameters

NO.6 Detailed Function Description
67
6.10 Communication function parameters
P163
Setting range
Unit
Ex-factory value
Alteration
Communication address
0-250
1
1
╳
When RS-485 communication port control is set for the inverter, the position of each inverter
shall be set via a parameter.
0: No communication function
01-250: Position of inverter
P164
Setting range
Unit
Ex-factory value
Alteration
Communication
transmission speed
0-3
1
2
╳
0:4800 bit/s
1:9600 bit/s
2:19200 bit/s
3:38400 bit/s
P165
Setting range
Unit
Ex-factory value
Alteration
Communication data
mode
0-5
1
3
╳
0:8N1 For ASCII
1:8E1 For ASCII
2:8O1 For ASCII
3: 8N1 For RTU
4: 8E1 For RTU
5: 8O1 For RTU
[Note] 8N1 For ASCII P165=0 or 8N1 For RTU P165=3
8E1 For ASCII P165=1 or 8E1 For RTU P165=4
8O1 For ASCII P165=2 or 8O1 For RTU P165=5
P166-P168
Reserve
P169
Setting range
Unit
Ex-factory value
Alteration
Communication protocol
0-1
1
1
╳