Operating MATRIX control panel MATRIX control panel
80 PR-2011-0110-GB • Subject to modifications • R9-03-2016
Sensor offset value submenu
You can enter an offset value (correction value) in the submenu "Sensor offset
value" to correct the measured room temperature. This menu option appears only
if the room temperature is detected with an integrated or a remote sensor.
Version info submenu
The "Version information" submenu provides information about the serial number
and software version of the MATRIX control panel.
The version information is important, for instance, when ordering spare parts or
calling the DencoHappel service hotline.
Change password submenu
You can change your password in the “Change password” submenu.
• First enter the desired password, then
• confirm the password by re-entering it again.
9 You will see this confirmation if the password was successfully changed.
Offset value
Sensor offset value
Value range: -10,0 to 10,0 °C [14 to 50 °F] or „--.-“*
Adjustable steps: 0,1 °C [1 °F]
Factory setting: "00.0"*
If "--:-" or "00.0 °C" is selected, then the offset value is switched off.
Versions Info
Serial #: 0001
Firmware: OP51C 1.00
Hardware: 1.00
Bus system: 1.00
Designation Explanation
Serial #: XXXX Serial No. of the MATRIX control panel
Firmware: OP5XX X.XX Type of control panel and version number of the
firmware (operating system)
Hardware: X.XX Version No. of the hardware
Bus system: X.XX Version number of the bus system to communicate
with other DencoHappel units.
Value range: 4-digit password, each consisting of characters
from 0 to 9 or A to Z
Change password
Enter password
****
****
Confirm password
Change password
Enter password
****
****
Confirm password
The password
was changed!
NOTICE!
The password assigned by you is used for the partial and complete
blocking of the control panel.
If you have forgotten your password, a general release and a redef-
inition of your password is possible with the password "M7G6".
To Next Page
Loading...
Need help?
General
